| BODY TYPE: |
Fully welded pressure and vacuum vessel for self filling and emptying of agricultural liquid effluent |
| CAPACITY |
16,900 litres |
| CUBIC CAPACITIY |
16.9m³ |
| TANKER LENGTH |
4,800mm + 800mm for dished ends |
| OVERAL LENGTH: |
8,100mm with drawbar and jetta fitted |
| TANK DIAMETRE |
2,000mm |
| OVERAL WIDTH: |
2,550mm |
| OVERALL HEIGHT |
3,340mm |
| AXLE SINGLE |
X |
| AXLE TANDEM |
Heavy Duty 100mm / 10 stud |
| WHEELS ON SINGLE |
X |
| WHEELS ON TANDEM |
500/60 x 22.5 road wheels |
| SUSPENSION |
Oscillating walking beam |
| MUDGUARDS |
Standard |
| CHASSIS |
Full Chassis 250 x 150 x 6 RHS |
| TANK SPEC |
Fabricated from 6mm plate, double welded to the ‘hot spun’ dished ends. 2 x internal baffles are welded in the tank to add strength and prevents surging |
| TANK JETTA |
Up to 20m spread width depending on viscosity of liquid pressured though a single conical nozzle on to a splash plate (see for options on effluent distribution) |
| TANK FEATURES |
"760mm diameter rear inspection access door - Hydraulically operated rear gate valve - Second port in rear dished end (big models) and also wash down port - Manual side gate valve on off side and blank port on near side - 1 x 4 metres of flexible suction hose 6’’ diameter & 1 x 3m galvanised suction pipe - Suction hose transport brackets both sides 3 x 75mm sight glasses (sight tube on big models) - 1 x large visual pressure gauge 1 x primary anti-overfill valves 1 x secondary overfill trap with drain" |
| PUMP |
"15,000 litres air / minute. Battioni Pagoni pump c/w
1 x pressure release valves
1 x vacuum release valve
1 x 540 rpm 6 spline PTO 60hp wide angle
oil cooler fitted as standard" |
| DRAW BAR SUPPORT |
100mm hydraulic stand |
| TOWING EYE |
50mm swivel eye |
| FINISH |
All vehicles are blasted, then etch primed allowed to dry then 2 x gloss coats |
| COLOUR |
Agmech Yellow / charcoal / wheels white |
| OPTIONS |
Discuss your individual requirements with your dealer as a range of options are available. |
