Unique features
- Low center of gravity
- Optimum ground clearance
- 2'' pitch floor chain with RHS bars
- Fully welded 200 x 100 section RHS chassis
- Straight drawbar for maximum turning circle
- 40mm bearings and shafts on shredders 50mm on shuttle drive
- Full steel floor welded to RHS frame
- 2 wire hose on all hydraulics
- Large axle and floatation wheels
- High torque hydraulic motor
- 43mm diameter swivel eye
| BODY TYPE: |
Flat floor one piece monocoque body, with top pipe rails 3mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| FEED OUT: |
Single shredder either side, each offset to the floor chain as well as near side being lower than off side |
| HYDRAULIC CONTROL: |
Controlled via the tractor remotes |
| CAPACITIES in Kgs: |
6000kgs |
| 4’ ROUND BALES: |
5 up to 6’ diameter |
| BODY LENGTH: |
7,550mm |
| OVERAL LENGTH: |
9,000mm |
| BODY WIDTH ID: |
1,520mm |
| OVERAL WIDTH: |
2,500mm at the shredders |
| AXLE TANDEM: |
60mm / 6 stud brakeless Oscillating Axle |
| WHEELS TANDEM: |
12.5 x 15.3 |
| SUSPENSION: |
Tandem walking balance beam |
| LOADING HEIGHT: |
1,200mm |
| CHASSIS: |
200 x 100 x 5mm fully welded chassis |
| HEADBOARD: |
Removable headboard with rails |
| DRAW BAR LENGTH: |
1,450mm fitted with 80mm jack support |
| SHUTTLE DRIVE: |
Single 3:1 on 13mm chain |
| TOWING EYE: |
Fixed eye |
| LOADING FOOT: |
Drop down foot is ideal to rest the unit on when loading, it digs into the ground assisting when rear loading, used in conjunction with a quick hitch |
| FINISH/COLOUR: |
Blasted, etch base zinc high build primer then dried. Followed by 2 x gloss coats of gloss paint Agmech Yellow, wheels white, door charcoal. |
Download or Print JUMBO J5 Specifications - Jumbo-STD-J5.pdf (168KB)
|
