| BODY TYPE: |
4mm Corten non rust steel deck (up to 12mm) sitting flat on top chassis with heavy floor bars and commercial side raves with fixed headboard - lift off sides are standard with optional bath tub body |
| CAPACITY: |
10 Tonnes Level Loaded |
| CAPACITIES: (Level Load) |
4.7m³ level loaded @ 2,000 kgs/m³ |
| BODY LENGTH: |
4,750mm |
| BODY WIDTH: |
2,500mm |
| BODY DEPTH: |
Lift off side 600mm
Monocoque body 700mm |
| LOADING HEIGHT: |
1,300mm Tandem Axle Ground to floor on standard wheels |
| OIL REQUIREMENT: |
15.5 litres of oil to lift to 60° and terminating at ½’’ QRC |
| RAM TYPE: |
1st stage 22.4 tonnes
2nd stage 16.1 tonnes
3rd stage 11.7 tonnes
4th stage 8.1 tonnes
5th stage 5.2 tonnes
Calulated at 180 bar |
| TANDEM AXLE: |
80mm / 8 stud brakeless
12,400kgs@ 40km/hr |
| WHEELS ON TANDEM: |
385 / 65 x 22.5 capacity of 16.2 tonne 65 km/hr |
| BRAKES: |
Optional |
| CHASSIS: |
200 x 100 x 6mm fully welded chassis |
| TOP CHASIS: |
152 x 76 RHS |
| FLOOR THICKNESS: |
4mm corten braced every 450mm nominal |
| SIDE THICKNESS: |
3mm with up right bracing |
| DRAW BAR: |
200 x 100 x 9mm on single bea |
| DRAW BAR SUPPORT: |
Fitted with 80mm jack suppor |
| TOW EYE: |
Swivel 50mm eye |
| SIDES: |
Standard with one piece lift off side for maximum strength, RHS top & bottom rails with upright bracing to welded sheet fitted with centre support extrusion - monocoque optional |
| HEADBOARD: |
Fixed headboard with 4 x upright RHS members locking in to the deck with 4mm steel welded with centre external extrusion, RHS double railed goal posts extension with entry steps fitted for access |
| TAILGATE: |
Standard with top hinged bottom locking tailgate with hinge point 200mm higher than side in forward position ensuring closing, made of RHS heavy duty frame and double skinned 3mm outer sheet and 3mm inner sheet set on angle |
| TAILGATE LOCKING: |
Fitted with hydraulic locking tailgate operated from the tractor cab, ensuring both emptying and locking is done quickly by the operator, fitted with spreading chains as standard - optional hydraulic up and over door |
| ROPE RAILS: |
Standard fitting with 1” bore pipe attached every third floor member to NZ standard 5444 |
| ROAD LIGHTS: |
Optional LED lights fitted to rear or front and rear |
| FINISH: |
Blasted, zinc base primer, 2 x gloss coats |
| COLOUR: |
Standard Yellow, Wheels White and Doors Charcoal |
| OPTIONS: |
Discuss your individual requirements with your dealer as a range of options are available. |
