Unique features
- Low center of gravity
- Tub body design for chopped bales
- Optimum ground clearance
- 2'' pitch floor chain with RHS bars
- Fully welded 200 x 100 section RHS chassis
- Straight drawbar for maximum turning circle
- 40mm bearings and shafts on shredders 50mm on shuttle drive
- Full steel floor welded to RHS frame
- 2 wire hose on all hydraulics
- Large axle and floatation wheels
- High torque hydraulic motor
- 43mm diameter swivel eye
- Self adjusting drive chain tensioners with ware block
- Unique loading arm for gentle loading of chopped bales (optional)
| BODY TYPE: |
Tub body one piece monocoque body, with RHS rails2mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| FEED OUT: |
Single shredder on near side, with fixed elevator on off side |
| HYDRAULIC CONTROL: |
Controlled via the tractor remotes with crossline relief on shuttle motor |
| CAPACITIES IN Kgs: |
7200kgs |
| 4’ ROUND BALES: |
6 up to 6’ diameter |
| BODY LENGTH: |
8,800m |
| OVERAL LENGTH: |
10,250mm |
| BODY WIDTH ID: |
1,999mm |
| OVERAL WIDTH: |
Body 2,667mm at widest |
| AXLE TANDEM: |
70mm / 6 stud brakelessrigid axle |
| WHEELS TANDEM: |
400 / 60 x 15.5 traction wheel |
| LOADING HEIGHT: |
1,600mm |
| CHASSIS: |
200 x 100 x 6mm fully welded chassis |
| HEADBOARD: |
Full mesh headboard |
| DRAW BAR LENGTH: |
1,450mm |
| SHUTTLE DRIVE: |
Single 4:1 on 13mm chain |
| TOWING EYE: |
Fixed eye |
| LOADING FOOT: |
Drop down foot is ideal to rest the unit on when loading, it digs into the ground assisting when rear loading, used in conjunction with a quick hitch |
| FINISH/COLOUR: |
Blasted, etch base zinc high build primer then dried. Followed by 2 x gloss coats of gloss paint Agmech Yellow, wheels white, door charcoal. |
Download or Print JUMBO JT6 Specifications - Jumbo-Tub-JT6.pdf (292KB)
|
