Unique features
- Low center of gravity
- Tub body design for chopped bales
- Optimum ground clearance
- 2'' pitch floor chain with RHS bars
- Fully welded 200 x 100 section RHS chassis
- Straight drawbar for maximum turning circle
- 40mm bearings and shafts on shredders 50mm on shuttle drive
- Full steel floor welded to RHS frame
- 2 wire hose on all hydraulics
- Large axle and floatation wheels
- High torque hydraulic motor
- 43mm diameter swivel eye
- self adjusting drive chain tensioners with ware blocks
- • 7m3 of pit silage (with panels fitted)
- • Unique loading arm for gentle loading of chopped bales (optional)
| BODY TYPE: |
Tub body one piece monocoque body, with RHS rails 2mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| FEED OUT: |
Single shredder on near side, with fixed elevator on off side |
| HYDRAULIC CONTROL: |
Controlled via the tractor remotes |
| CAPACITIES IN kgs |
3600kgs |
| 4’ ROUND BALES: |
4 up to 6’ diameter |
| BODY LENGTH: |
5,050mm |
| OVERAL LENGTH WITH DRAW BAR: |
6,560mm |
| BODY WIDTH ID: |
1,999mm |
| OVERAL WIDTH: |
Body 2,667mm at widest |
| AXLE SINGLE: |
60mm / 6 stud brakeless Rigid Axle |
| WHEELS SINGLE: |
11.5 / 75 x 15.3 |
| LOADING HEIGHT: |
1,450mm |
| CHASSIS: |
200 x 100 x 4mm fully welded chassis |
| HEADBOARD: |
Full mesh headboard |
| BODY: |
2mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| DRAW BAR LENGTH: |
1,450mm |
| SHUTTLE DRIVE: |
Single 3:1 on 10mm chain |
| LOADING FOOT: |
Drop down foot is ideal to rest the unit on when loading, it digs into the ground assisting when rear loading, used in conjunction with a quick hitch |
| FINISH/COLOUR: |
Blasted, etch base zinc high build primer then dried. Followed by 2 x gloss coats of gloss paint Agmech Yellow, wheels white, door charcoal. |
Download or Print JUMBO JT3 Specifications - Jumbo-Tub-JT3.pdf (168KB)
|
