Unique features
- Low center of gravity
- Optimum ground clearance
- 2'' pitch floor chain with RHS bars
- Fully welded 200 x 100 section RHS chassis
- Straight drawbar for maximum turning circle
- 40mm bearings and shafts on shredders 50mm on shuttle drive
- Full steel floor welded to RHS frame
- 2 wire hose on all hydraulics
- Large axle and floatation wheels
- High torque hydraulic motor
- 43mm diameter swivel eye
.jpg)
| BODY TYPE: |
Flat floor one piece monocoque body, with top pipe rails 3mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| FEED OUT: |
Single shredder either side, each offset to the floor chain as well as near side being lower than off side |
| HYDRAULIC CONTROL: |
Controlled via the tractor remotes |
| CAPACITIES IN Kgs: |
8400kgs |
| 4’ ROUND BALES: |
7 up to 7’ diameter |
| BODY LENGTH: |
10,050mm |
| OVERAL LENGTH: |
11,500mm |
| BODY WIDTH ID: |
1,520mm at pipe rails |
| OVERAL WIDTH: |
2,500mm at the shredders |
| AXLE TANDEM: |
70mm / 6 stud brakeless Oscillating Axle |
| WHEELS TANDEM: |
400 / 60 x 15.5 |
| LOADING HEIGHT: |
1,250mm |
| CHASSIS: |
200 x 100 x 6mm fully welded chassis |
| HEADBOARD: |
Removable headboard with rails |
| DRAW BAR LENGTH: |
1,450mm fitted with 60mm jack support |
| SHUTTLE DRIVE: |
Single 4:1 on 13mm chain |
| TOWING EYE: |
Fixed eye |
| LOADING FOOT: |
Drop down foot is ideal to rest the unit on when loading, it digs into the ground assisting when rear loading, used in conjunction with a quick hitch |
| FINISH/COLOUR: |
Blasted, etch base zinc high build primer then dried. Followed by 2 x gloss coats of gloss paint Agmech Yellow, wheels white, door charcoal |
Download or Print JUMBO J7 Specifications - Jumbo-STD-J7.pdf (168KB)
|
