Unique features
- Low center of gravity
- Optimum ground clearance
- 2'' pitch floor chain with RHS bars
- Fully welded 200 x 100 section RHS chassis
- Straight drawbar for maximum turning circle
- 40mm bearings and shafts on shredders 50mm on shuttle drive
- Full steel floor welded to RHS frame
- 2 wire hose on all hydraulics
- Large axle and floatation wheels
- High torque hydraulic motor
- 43mm diameter swivel eye
| BODY TYPE: |
Flat floor one piece monocoque body, with top pipe rails 3mm sheet steel with nominal spaced profiles supported by under sheet bracing |
| FEED OUT: |
Single shredder either side, each offset to the floor chain as well as near side being lower than off side |
| HYDRAULIC CONTROL: |
Controlled via the tractor remotes with crossline relief on shuttle motor |
| CAPACITIES in Kgs: |
4800kgs |
| 4’ ROUND BALES: |
4 up to 6’ diameter |
| BODY LENGTH: |
6,300mm |
| OVERAL LENGTH: |
7,750mm |
| BODY WIDTH ID: |
1,520mm |
| OVERAL WIDTH: |
Body 2,500mm at the shredders |
| AXLE TANDEM: |
50mm / 6 stud brakeless Oscillating Axle
|
| WHEELS TANDEM: |
11.5 x 15.3 |
| LOADING HEIGHT: |
1,150mm |
| CHASSIS: |
200 x 100 x 4mm fully welded chassis |
| HEADBOARD: |
Removable headboard with rails |
| DRAW BAR LENGTH: |
1,450mm fitted with 70mm jack support |
| FLOOR THICKNESS: |
Single 3:1 on 10mm chain |
| TOWING EYE: |
Fixed eye |
| LOADING FOOT: |
Drop down foot is ideal to rest the unit on when loading, it digs into the ground assisting when rear loading, used in conjunction with a quick hitch |
| FINISH/COLOUR: |
Blasted, etch base zinc high build primer then dried. Followed by 2 x gloss coats of gloss paint Agmech Yellow, wheels white, door black |
Download or Print JUMBO J4 Specifications - Jumbo-STD-J4.pdf (168KB)
|
